Plug & Play Feature
When the TV is initially powered on, basic settings proceed automatically and subsequently.
1. Press the POWER (_ button on the remote control.
You can also use the POWER (_ button on the TV.
The message Select Language of the OSD. is displayed.
2. Press the A or T button to select the language, then press the ENTER[B,_ button. The
message Select 'Home Use' when installing this TV in your home. is displayed.
3. Press the _ or _ button to select Store Demo or Home Use, then press the ENTER C,_ button. The message Select the
Antenna source to memorize, is displayed.
We recommend setting the TV to Home Use mode for the best picture in your home environment.
Store Demo mode is only intended for use in retail environments. If the unit is accidentally set to Store Demo mode and
you want to return to Home Use (Standard): Press the volume button on the TV. When the volume OSD is displayed,
press and hold the MENU button on the TV for 5 seconds.
4. Press the A or _ button to memorize the channels of the selected connection. Press the ENTER [E ,# button to select Start.
Air: Air antenna signal. / Cable: Cable antenna signal. / Auto: Air and Cable antenna signals.
In Cable mode, you can select the correct signal source among STD, HRC, and IRC by pressing the A, T, _ or _,-
button, then press the ENTER [B ,# button. If you have Digital cable, select the cable system signal source for both Analog
and Digital. Contact your local cable company to identify the type of cable system that exists in your particular area.
6. Press the ENTERI--} , # button to select Start. The TV will begin memorizing all of the available channels.
To stop the search before it has finished, press the ENTER[B,# button with Stop selected.
After all the available channels are stored, it starts to remove scrambled channels. The Auto program menu then
reappears. Press the ENTER _,_ button when channel memorization is complete. The message Set the Clock Mode. is
displayed.
6. Press the ENTERI_,,_button.
Press the A or T button to select Auto, then Press the ENTERI:E# button. The message Set to daylight saving time. is
displayed. If you select Manual, Set current date and time is displayed.
7. Press the A or T button to select Off, On or Auto, then press the ENTERI:E# button.
8. Press the A or T button to highlight the time zone for your local area. Press the ENTER C_ button. If you have received a
digital signal, the time will be set automatically. If not, see page 22 to set the clock.
9. The connection method to provide the best quality HD is offered. After confirming the method, press the ENTER C_ button.
10. The message Enjoy your watching, is displayed. When you have finished, press the ENTER C_ button.
If you want to reset this feature...
1. Press the MENU button to display the menu. Press the A or T button to select Setup, then press the ENTER C.,Jbutton.
2. Press the ENTERI:E# button again to select Plug & Play.
The Plug & Play feature is only available in the TV mode.