Samsung 5 Serie Manual Del Usuario página 35

[3
Setting Up Anynet +
_-_ Press the TOOLS button to display the Tools menu. You can also display Anynet+ menu by selecting Tools _ Anynet +
(HDM[-CEC).
Setup
Anynet+ (HDMI-CEC) _ Off / On
To use the Anynet + Function, Anynet + (HDMI-CEC) must be set to On.
When the Anynet + (HDMI-CEC) function is disabled, all the Anynet + related operations
are deactivated.
Auto Turn Off _ No / Yes
Setting an Anynet + Device to turn OffAutomatically when the TV is Turned Off
{_ The active source on the TV remote must be set to TV to use the Anynet + function.
{_ If you set Auto Turn Off to Yes, connected external devices are also turned off when the
TV is turned off. If an external device is still recording, it may or may not turn off.
Switching between Anynet + Devices
1.
2.
3.
%
%
%
%
%
Press the TOOLS button. Press the ENTERI:E_ J button to select Anynet + (HDMI-CEC).
Press the A or T button to select Device List, then press the ENTER C_Jbutton.
{_ Anynet + devices connected to the TV are listed.
{_ If you cannot find a device you want, press the red button to scan for devices.
Press the A or V' button to select a particular device and press the ENTERI:::C ,,Jbutton. It
is switched to the selected device.
{_ Only when you set Anynet + (HDMI=CEC) to On in the Application menu, the Device
List menu appears.
Switching to the selected devices may take up to 2 minutes. You cannot cancel the
operation during the switching operation.
The time required to scan for devices is determined by the number of connected devices.
When the device scan is complete, the number of devices found are not displayed.
Although the TV automatically searches the device list when the TV is turned on via the power button, devices connected to
the TV when the TV is on or under some conditions are not automatically displayed in the device list. Press the red button to
search for the connected device.
If you have selected external input mode by pressing the SOURCE button, you cannot use the Anynet + function. Make sure to
switch to an Anynet + device by using the Device List.