Infrared remote control (see fig. C)
The vacuum cleaner must always be switched on at the main appliance first.
On/off symbol → starts/stops the device. After stopping, the vacuum cleaner is in standby mode.
+ → increases the suction power
- → reduces the suction power
Note: if the red LED on the handle does not light up when the buttons are pressed, check the batteries.
Suction modes
The selected suction power is shown on the display of the main appliance.
Weak
For textiles
(e.g. curtains)
4. When you have finished using the appliance, unplug the mains cable from the socket.
5. Press the blue handle on the main unit to pull the cable back inside the appliance.
6. The blue handle can be folded upwards to transport the appliance.
Cleaning and user maintenance
WARNING!
Risk of electric shock
Switch the appliance off and disconnect it from the mains before cleaning or
user maintenance.
Never hold the appliance under running water or immerse it in water or other liquids.
Clean the appliance by wiping it with a dry cloth.
Do not use harsh or abrasive cleaning agents or cleaning pads.
The accessories can be wiped with a damp cloth if necessary.
Emptying the dust container (see fig. D & E)
1. Unlock the dust container by pressing the unlock button above the display and remove the container.
2. Press the handle above the filter towards the cover to remove the cover.
3. Empty the dust container.
4. Replace the cover by first inserting the lug on the handle and then snapping the cover into place.
5. Put the dust container back into the main appliance.
Cleaning the dust container filter (see fig. F)
1. Open the cover.
2. Remove the filter unit by pressing the lug above the filter.
3. The sponge filter can be washed out under running water if necessary.
4. The HEPA filter (paper filter) should be thoroughly knocked out.
5. Reassemble the filter in reverse order and insert it into the appliance.
Instruction manual
Medium
Upholstered furniture,
runners, etc.
Strong
Hard floor
(highest suction power)
GB
Carpet mode
17