Publicidad
Idiomas disponibles
Idiomas disponibles
When installing the hob onto a cabinet, a
shelf must be installed in order to separate
the cabinet from the hob as illustrated in the
above figure. This is not required when
installing onto a built-in oven.
Ll the oven is below:
A
ki is required to | leave a ventilation opening of — 5
minimum 180 cm" at the rear section of the
ita as illustrated in the following figure. _
-
2
min. 25mm
1
Hob
2
Oven
y the board is below:
*
min.
i
min. 25 mm
During installation of your induction hob, place
the product parallel to the installation surface.
Also, apply sealing gasket to the parts of the hob
contacting the counter as described below in
order to prevent any liquid from penetrating
between the product and the counter.
1. Prepare the surface of the counter as shown
in the figure.
2. Apply the sealing gasket provided with the
product to the edges of the hob's lower
housing that contact with the counter as
illustrated in figure.
3. Center the product in the counter.
4, Using the installation clamps secure the hob
by fitting through the holes on the lower
Ñ
min. 30 mm
1
Hob
2
Installation clamp
3
Counter
11/EN
Publicidad
