Publicidad
Idiomas disponibles
Idiomas disponibles
Overheating protection
Your hob is equipped with some sensors
ensuring protection against overheating.
Following may be observed in case of
overheating:
e
Active cooking zone may be turned off.
e
Selected level may drop. However, this
condition cannot be seen on the indicator.
e
E2 error might be given.
Overflow safety system
Your hob is equipped with overflow safety system.
If there is any overflow that spills onto the control
panel, system will give error and the hob will be
automatically turned off.
Precise power setting
Induction hob reacts the commands immediately
as a feature of its operating principles. lt changes
the power settings very fast. Thus, you can
prevent a cooking pot (containing water, milk and
etc.) from overflowing even if it was just about to
overflow.
Operating noisy
Some noises may arise from the induction hob.
These sounds are normal and a part of induction
cooking.
e
Noise becomes prominent in high
temperature levels.
e
Alloy of the saucepan can cause noise.
e
|n low levels, a regular on/off sound can be
heard because of the operating principles.
e
Noise can be heard if an empty saucepan is
heated. When you put water or food in it,
this sound will clear away.
20/EN
The noise of the fan that cools electric
system can be heard.
Error messages
Table-2: Error codes and error sources
For further information about error
f messages that may appear on the touch
control panel, see Table-2.
If the surface of the touch control panel is
exposed to intense vapor, entire control
system may become deactivated and give
error signal,
Keep the surface of the touch control panel
clean. Erroneous operation may be
Publicidad
