Publicidad
Idiomas disponibles
Idiomas disponibles
EN
3. product components
1. Moving blade
2. Fixed blade
3. Gear
4. Trigger
5. Battery connection cable
6. Charger
NOTE: When the diameter is set to the smallest position, the blade adjusts to a smaller sprocket
to increase battery speed and efficiency.
4. use and maintenance
Commissioning:
1. Open the case and place the battery pruner and its battery in the appropriate storage bag.
2. The battery pruner has a fixed connection power cable through the harness and connects to the battery.
Wear the harness (the power supply cable must be placed in the retaining buckle to avoid cutting the cable
when in use) as shown in Figures 1 and 2.
3. Take out the battery pruner, flip the battery power switch, until you hear "di" for once; check that the
battery supplies power normally, as shown in Figure 3.
4. Press the trigger continuously and quickly for two times, open the blade automatically.
5. Before working, press the trigger to operate the blade several times and listen for any noise of too fast
or too slow phenomena.
6. After verifying that everything runs normally, start working.
7. The opening of the blade can be changed; press the trigger and release it after hearing "didi" twice; the
blade opening will change automatically.
8. Power off: press the trigger and release it after hearing "dididi" three times; the blade will close
automatically.
9. Turn off the battery switch.
1
3
2
7. Charge indicator (press to see)
8. Charger connection
9.Charger entry point
10. Battery switch
11. Battery current output
12. Pruner cable connection
4
4
5
8
9
10 11 12
6
7
Publicidad
