Publicidad
Idiomas disponibles
Idiomas disponibles
SKF Lubrication Systems Germany GmbH
EMAIL: robert.collins@skf.com WEBSITE:
This Declaration of Incorporation is issued
under sole responsibility of the
manufacturer. Lincoln Industrial Corporation
hereby declares that the partly completed
machinery stated below:
Name: PowerMaster
Model number(s): 84335
Description: Stub pump tube (series C)
Year of CE: 2023
in its intended use, is in conformity with the
relevant union harmonization legislation:
Machinery Directive 2006/42/EC
(Article 13 Partly Completed Machinery)
I, the undersigned of Lincoln Industrial Corporation, do hereby declare that the equipment specified above, in its intended use, conforms to
the requirements of the above EC Directive(s).
___________________________________
Robert Collins
Technical Compliance Manager
St. Louis, MO, U.S.A.
2023/08/28
Declaration of Incorporation *
Manufacturer name/address:
Lincoln Industrial Corporation
5148 N. Hanley Road
St. Louis, MO 63134 U.S.A.
TEL: +1 (314) 679-4200 FAX: +1 (314) 679-4367
Authorized to compile the technical file:
Heinrich-Hertz-Straße 2-8
69190 Walldorf, Germany
TEL: +49 (0) 6227-330
and conforms to the following harmonized
standards:
EN 4413:2010
Hydraulic fluid power - general rules and
safety requirements for systems and their
components.
EN 12162:2001+A1:2009
Liquid pumps - safety requirements -
procedure for hydrostatic testing.
EN ISO 809:1998+A1:2009
Pumps and pump units for liquids -
common safety requirements.
EN ISO 12100:2010
Safety of machinery. General principles
for design. Risk assessment and risk
reduction.
www.skf.com
The following EHSR (Essential Health and
Safety Requirements) have been applied:
1.1.2a – 1.1.2b – 1.1.2c – 1.1.3 – 1.1.5 –
1.2.5 – 1.3.2 – 1.3.3 – 1.3.4 – 1.3.5 – 1.3.6
– 1.3.7 – 1.3.8 -1.5.3– 1.5.4 – 1.5.13 –
1.7.1 – 1.7.1.1 – 1.7.3 – 1.7.4
The manufacturer maintains a technical file
summary sheet containing test reports and
product documentation:
Technical file summary sheet number:
RA404214
The partly completed machinery shown
above should not be put into service until the
final machinery into which it is to be
incorporated has been declared in conformity
with the provisions of the directive, where
appropriate.
* Indicates change.
3
DOCUMENT NUMBER
409191.DoI
Publicidad
