Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
11
Installing the escutcheon
and handle
□
Install the escutcheon (E) onto the valve body (D)
using the escutcheon screws (M).
□
Place the handle (F) onto the valve body (D) and
tighten the set screw (G) with the Hex wrench
(Hex: 2.5 mm, H) provided.
12
Checking for leaks
□
Turn the handle (F) to the full on mixed position.
□
When the valve body (D) is turned on, water
normally ows through the tub spout (J). To
activate the shower, turn the valve on and pull
the knob (1) up. Hold the knob (1) until the water
ows continuously from the shower arm (B).
Check for leaks.
□
Shut off the water at the faucet and supply lines.
NOTE: When the pattern of the water ow switches to
the shower from the tub spout, some small leakage from the
tub spout is a normal occurrence. If water comes out of the
tub spout and showerhead at the same time, be sure to pull
the knob (1) up fully.
1
J
F
G
H
UP
FOR
SHOWER
E
M
J
14
B
F
D
D
Publicidad
