Publicidad
Idiomas disponibles
Idiomas disponibles
water source <<<If the water inlet connector has been
installed, skip the steps for installing the water inlet connector.>>>
WARNING: The appliance is INTENDED to be used at a temperature above 0 degree.
WARNING: Garden hose can not be damaged and leak, Inner diameter less than 1/2 „inches, the length can not be greater than 8 m.
9. Connect to the power supplier, Plug the pressure washer into the power outlet. Push button to remove the hose
10. Service parts: seal ring replacement
Attention: If the leakage is happend, please check the seal ring. And change it with a new one when the sealring is failed. Follow the pictu-
re, choose the correct seal ring for the replacement.
* mm*
. *
HIGH PRESSURE HOSE
NOZZLE
* . mm*
SPRAY LANCE
OPERATING
WARNING - DANGER!
During operation the appliance must be positioned on a firm, stable surface.
WARNING: High pressure hose must not loop.
Starting Up
1. Turn the water source on. Squeeze the trigger about 1 minute until low pressure water flow out to empty air out of the unit.
Warning: This unit is intended to be used with cold water only! Do not use hot water in this pressure cleaner!
2. Turn the switch of the pressure wash to" ON/I" position, then pull the trigger till all the air is pushed out of machine and water flows from
the gun.
23
Adres producenta/ Adresse des Herstellers/ Manufacturer's Address/ Адрес производителя
GTV Poland Sp. z o.o. Sp. k., ul. Przejazdowa 21, 05-800 Pruszków
Publicidad
