Publicidad
Idiomas disponibles
Idiomas disponibles
Friction Style - Fully extend the drawer. Insert screwdriver
into the slot in the side and push in on the stop until it
clears the lance. Pull drawer just past lance before
releasing stop. Repeat the process for the other slide.
CASTER INSTALLATION
Items Needed:
1/4 - 20 x 5/8-in (Qty: 16)
1/4 - 20 Nut (Qty: 16)
3/8-in Wrench
Process:
• Remove bottom drawers.
• Lay the cabinet on its back. Use packaging material to
protect the finish.
• Mount both swivel casters on the same side of the unit.
• Attach the casters using four screws and nuts per caster.
• Wrench tighten all screws. It is recommended not to
exceed 80 inch pounds of torque.
• Return the unit to its upright position.
• Reinstall bottom drawers (see step 3).
Nut
Screw
INSTALLING DRAWERS
Ball bearing slide - Pull slides and slide carrier out to fully
extended position (see illustration.) Hold the slide on the
cabinet while aligning it with the slide on drawer. Slightly
insert one side and repeat for the other side. Slowly push
drawer to its fully closed position to engage slide. Open
drawer and reclose to ensure proper operation.
slide carrier
3
slide
Publicidad
