Create Speaker Fire Manual De Instrucciones página 10

Idiomas disponibles

LOA DIN G P ORT

LOW BAT TE RY AND CH ARGI NG

• If the speaker is not charged after a period of time, it will automatically turn off.

• Insert the type C cable to charge the speaker (5V/2A charging cable). The red indicator

light will illuminate during charging.

• The indicator light will turn green when the speaker is fully charged.

Warning: Always use a 5V charger to charge the device. Otherwise, it will cause damage to

the speaker or accident caused by charging the wrong adapter.

AU X ILIARY CONNECT I O N

T WS CON N ECTION

1. Turn on both speakers.

2. Press the power button twice. The speakers will enter pairing mode and the indicator light

will flash orange quickly.

3. After pairing is completed, the indicator light on the master speaker will remain on and the

linked speaker will flash slowly.

4. To disconnect pairing, short press the power button once to disable TWS pairing.

5. When the speakers are paired by equipment, insert the cable into the auxiliary jack on the

rear panel of the master speaker.

6. Both speakers can be turned off via TWS pairing mode.

R E SE T B U T TON

E NGL I SH

• Insert the cable into the Type-C charging port to charge the

speaker.

• When the battery capacity is low, the voice prompt will sound

"Low battery" to remind the user that the speaker needs to

be charged.

• Insert the cable into the auxiliary socket. The speaker will

switch to auxiliary mode automatically.

• The indicator light will turn green when switching to auxiliary

mode.

• When the indicator light shows blue, Bluetooth will be

disabled.

• Remove the auxiliary cable and the Bluetooth mode will be

activated automatically and a beep will sound.

• The TWS function allows you to link two speakers at the

same time. The first speaker will be the master connected

to the Bluetooth device and will handle all controls including

power on and off. The second speaker is a speaker linked to

the master.

• Use a toothpick or pin to press the reset button to restart the

device in case the system stops.