EGO ST1520S Manual Del Operador página 31

PROBLEM
The cutting line
cannot be wound
into the trimmer
head properly.
The cutting line
cannot be passed
through the
trimmer head when
inserting the line.
56-VOLT LITHIUM-ION CORDLESS 15" STRING TRIMMER—ST1520 & ST1520S
CAUSE
◾
The cutting line is too long.
◾
Improper cutting line is
used.
◾
Grass debris or dirt has
accumulated in the
trimmer head and blocked
the movement of line
spool.
◾
Motor is overheated due to
repeatedly operating the
line winding system.
◾
Low battery
◾
The cutting line is split or
bent at the end.
◾
The lower cover is not
released to position after
reinstalling.
SOLUTION
◾
Cut the line so that about 5.5 in.
(14cm) long is showing on each side.
◾
We suggest that you use EGO
original nylon cutting line, see
"Recommended Cutting Line"
section in this manual. If using EGO
nylon line and the problem persists,
please call EGO customer service for
advice.
◾
Remove the battery, open the
trimmer head and clean it
thoroughly.
◾
Let the string trimmer work under
no load for a few minutes to cool the
motor, then try to reload the line.
◾
Charge the battery.
◾
Cut the worn end of line and reinsert.
◾
Attach the battery pack onto the
trimmer; press the line loading
button to briefly start the power
loading to release the lower cover.
31