brondell CIRCLE RC100 Manual De Usuario página 14

PRODUCT INSTALLATION (cont.)
STEP 3: DRAIN CLAMP INSTALLATION (cont.)
3. Align the drain clamp to the hole
a. Take the front half of the drain saddle (wih the 1/4 inch
quick connector opening) and unscrew the grey quick
connector from the saddle as shown.
b. Insert a screwdriver, straw, or similar straight thin item into
the front of the first half of the saddle (to use as a guide) as
shown here.
c. Insert the end of the guide into the 1/4 inch hole in the
drain pipe and slide the clamp until secure against the
drain pipe. The hole is now properly lined up with the
drain clamp hole. Hold secure by keeping the guide
inserted until the clamp is secured by screwing on the
back side as shown here.
4. Once the drain clamp is secure and tight on the pipe,
remove the guide and screw the 1/4 inch Quick Connector
back into place.
5. Lastly, insert the white colored drain tube into the 1/4 inch
Quick Connector on the drain clamp and push firmly into
place.
12
3
a
3
b
3
c
4–5