Kärcher LBL 2 Battery Manual Del Usuario página 6

Initial startup
Inserting the battery pack
ATTENTION
Dirty contacts
Damage to the device and battery
Check the battery mount and the contacts for soiling
and clean them as necessary before inserting the bat-
tery.
Illustration E
1. Push the battery into the mounting in the device until
it audibly latches into place.
Removing the battery
WARNING
Uncontrolled startup
Risk of injury
Remove the battery pack from the device during work
breaks and before carrying out any service or care work.
Illustration F
1. Press the unlocking button.
2. Remove the battery from the device.
Switch the device on and off
Use the power switch to switch the device on and off.
1. Slide the power switch forwards.
The device starts up.
2. Slide the power switch backwards.
The device stops.
Transport
CAUTION
Risk of injury and damage!
Injury or damage due to non-observance of the weight.
Be aware of the weight of the device during transport
and storage.
Storage
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during storage.
Note
Always store the device in a dry place and remove the
battery pack.
Care and service
The device is maintenance-free.
Troubleshooting guide
Malfunctions often have simple causes that you can
remedy yourself using the following overview. When in
doubt, or in the case of malfunctions not mentioned
here, please contact your authorised Customer Service.
As the battery pack ages, even if it is looked after, its ca-
pacity reduces such that the full run time will no longer
be reached when fully charged. This does not indicate a
defect.
Type plate
The major device information is specified on the type
plate.
The location of the type plate on the device is specified
in the "Device description" chapter.
Faults on the device
The device does not start up
6
The battery pack is not inserted correctly.
1. Push the battery pack into the mounting in the de-
vice until it audibly latches into place.
The battery pack is discharged.
1. Charge the battery pack.
The battery pack is in sleep mode.
1. Press and hold the power switch longer or press the
power switch a second time.
The battery pack is defective.
1. Replace the battery pack.
The device stops during operation
The battery has overheated
 Stop working and allow the battery to cool down to
the permissible temperature range. This can take a
few minutes.
The warranty conditions issued by our relevant sales
company apply in all countries. We shall remedy possi-
ble malfunctions on your appliance within the warranty
period free of cost, provided that a material or manufac-
turing flaw is the cause. In a warranty case, please con-
tact your dealer (with the purchase receipt) or the next
authorised customer service site.
(See overleaf for the address)
Further warranty information (if available) can be found
in the service area of your local Kärcher website under
"Downloads".
Technical data
Device performance data
Maximum air speed
Maximum volume flow rate
Working voltage of the battery
Speed control
Speed levels
Battery pack included
Battery charger type
Dimensions and weights
Weight
Length x width x height
Subject to technical modifications.
English
Warranty
km/h
3
m /h
V
kg
mm
210
220
18
-
-
-
-
2,0
975 x
170 x
305