Whirlpool 3DWED4800YQ2 Manual De Uso Y Cuidado página 8

3.
Select the desired cycle
OFF 7O TIMED
60 DRY
50
WRINKLE
SHmELD
4O
Cool
Down
Less Dry
ENERGY
Normal Dry
lO
2o
3o
Damp Dry
2O
5. Select End of Cycle Signal
(if desired)
O 1
PUSH TO START
Turn the END OF CYCLE SIGNAL knob to select the desired
setting (On or Off). The End of Cycle Signal produces an
audible sound when the drying cycle is finished. Promptly
removing clothes at the end of the cycle reduces wrinkling.
Select the desired cycle for your load. See the Cycle Guide
for more information about each cycle.
AUTOMATIC DRY Cycles
You can select a different dryness level, depending on your
load, by turning the knob to dryness level.
Selecting Very Dry, ENERGY PREFERRED, or Less Dry
automatically adjusts the dryness level at which the dryer will
shut off. Once a dry level is set, it cannot be changed without
stopping the cycle.
AUTOMATIC DRY cycles give the best drying in the shortest
time. Drying time varies based on fabric type, load size, and
dryness setting.
NOTE: Very Dry removes more load moisture. ENERGY
PREFERRED is used for a starting point for AUTODRY cycles.
Choose ENERGY PREFERRED for optimal energy savings.
Less Dry removes less moisture and used for loads you may
want to put on a hanger to complete drying.
4, Set cycle settings
6. Press PUSH to START to
begin cycle
O 1
PUSH
TO START
Push and hold the PUSH to START knob to begin the cycle.
Promptly remove garments after cycle has completed to
reduce wrinkling.
0 1
Select cycle settings by turning the knob to the desired
position.
TEMPERATURE / FABRIC
Turn the TEMPERATURE / Fabric knob to change the drying
temperature setting. See "Setting the Drying Temperature".
WRINKLE SHIELD (ON SOME MODELS}
[] To get heat-free, periodic tumbling at the end of a cycle,
turn the WRINKLE SHIELD knob to ON or OFF at any
time before the cycle has ended.
NOTE: This option is available only on Automatic Cycles.
8