Alpine S-A60M Manual De Operación página 12

Ocultar thumbs Ver también para S-A60M:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Crossover Frequency Adjustment Knob
(LP FILTER) (S-A60M/S-A55V only)
Use this control to adjust the crossover
frequency between 50 Hz to 400 Hz.
Bass EQ Adjustment Knob (S-A60M/S-A55V
only)
Add a 50 Hz bass boost up to +12 dB to tune
your bass response.
Crossover Mode Selector Switch (S-A32F
only)
a) Set to the "OFF" position when the
amplifier will be used for driving
full range speakers or when using
an external electronic crossover.
The full frequency bandwidth will
be output to the speakers with no
high or low frequency attenuation.
b) Set to the "HP" position when the
amplifier is used to drive a tweeter/
midrange system. The frequencies
below the crossover point will be
attenuated at 12 dB/octave.
NOTE:
• In this case the maximum Bass EQ
boost level is reduced.
c) Set to the "LP" position when the
amplifier is used to drive a
subwoofer. The frequencies above
the crossover point will be
attenuated at 12 dB/octave.
Crossover Frequency Adjustment Knob
(S-A32F only)
Use this control to adjust the crossover
frequency between 50 Hz to 400 Hz.
Input Channel Selector Switch (CH-3/4)
(S-A55V only)
a) This switch setting is for selecting
either 2-channel or 4-channel input
mode. When set to "1/2", signal will
be copied from CH-1/2 and sent to
CH-3/4, eliminating the need for
Y-adapters.
b) Setting this switch to "3/4" will keep
both inputs, CH-1/2 and CH-3/4
independent.
A 4-channel source is required for
this mode.
10
-EN
ALPINE S-A60M/S-A32F/S-A55V 68-35792Z59-A (EN/FR/ES)
Crossover Frequency Adjustment Knob (HP
FILTER) (S-A55V only)
Use this control to adjust the crossover
frequency between 50 Hz to 400 Hz.
Input Channel Selector Switch (SUB) (S-A55V
only)
a) When this switch is placed in the
"1+2+3+4" position, all the signals
are mixed and come out from the
subwoofer. This setting provides
signal to the subwoofer channel
when only 4 channel input is
available.
b) Setting this switch to "SUB" will
send the signal at the inputs of SUB
to subwoofer of the S-A55V.
About
Lights up
Is off whe
Indica
Blue
Red
(blinking
Red

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

S-a32fS-a55v

Tabla de contenido