Publicidad
Idiomas disponibles
Idiomas disponibles
2. Recap the foam cannon bottle, and attach it to the trigger
gun via the spray wand assembly. Using the locking lugs,
twist clockwise to lock each component in place (Fig. 16).
Fig. 16
Trigger gun
Locking
lugs
Foamer cannon bottle
3. The foam cannon bottle is equipped with a foam-volume
knob. Follow the instructions as shown to use the foam-
volume knob (Fig. 17).
Fig. 17
4. Apply detergent from the bottom to the top of the dry
surface to be cleaned. Applying detergent in this manner
will dissolve dirt most effectively.
NOTE: Wetting the surface first is not recommended as it
dilutes the detergent and reduces its cleaning ability.
m
CAUTION!
Always test the detergent in an
inconspicuous area before use.
5. Allow the detergent to remain on the surface for a short
time before rinsing with the pressure washer. Do not allow
the detergent to dry on the surface.
m
CAUTION!
Damage may occur to painted surfaces if
the detergent is allowed to dry on the surface. Wash and rinse
a small section at a time. Avoid working on hot surfaces or in
direct sunlight.
Spray wand assembly
Foam-volume
knob
6. Rinse with clean water. When working on a vertical
surface, wash from the bottom up, then rinse from the top
down to avoid streaking. Hold the nozzle 6-8 inches away
from the work surface at a 45° angle.
m
IMPORTANT!
NEVER USE:
• Bleach, chlorine products, and other corrosive chemicals
• Liquids containing solvents (e.g. paint thinners, gasoline,
oils)
• Tri-sodium phosphate products
• Ammonia products
• Acid-based products
These chemicals will harm the unit and will damage the
cleaning surface.
Using the Feather Bristle Pressure
Washer Utility Brush
The Sun Joe
feather bristle pressure washer utility brush
®
safely cleans painted, topcoat, and delicate surfaces.
Compatible with all Sun Joe
1. If not already done, detach your spray wand from your
trigger gun.
2. Take the utility brush and align the two tabs with the inside
of the trigger gun (Fig. 18).
Fig. 18
3. Once aligned, push the utility brush into the trigger gun,
twist counterclockwise to lock into place.
Using the Wheel + Rim Brush
The Sun Joe
wheel + rim brush safely cleans wheels and
®
rims. Compatible with all Sun Joe
washers.
1. Disconnect the spray wand from the trigger gun by
pressing it in firmly and twisting clockwise until the 2
locking tabs of the lance can be removed from the slot.
2. Take the wheel + rim brush and align the two tabs with the
inside of the trigger gun (Fig. 19).
10
SPX series pressure washers.
®
Locking tab
Utility brush
SPX series pressure
®
Publicidad
