Descargar Imprimir esta página

Mx Onda MX-PB2470 Manual De Instrucciones página 55

Báscula de baño electrónica con medición del porcentaje de grasa corporal, agua, masa muscular y masa ósea

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
PREPARATION OF BATHROOM SCALE
This device uses three batteries of 1.5 V type AAA, for the placement or
replacement of the same follow the following steps:
1. Remove the lid of the battery compartment located at the base of the
scale.
2. Insert three 1.5 V AAA batteries, respecting the indicated polarity.
3. Replace the battery compartment cover.
With the scale on, press the selector button of the weight unit located at the
base of the scale, each press of this button will change the unit of weight
kilograms (Kg), pounds (lb) or stones (st).
WEIGHT MEASUREMENT
Gently climb the scale (for maximum precision, do not move until the
screen shows a stable reading), the scale will automatically turn on and
start reading the weight. When the reading is finished, the screen will show
the flashing digits for a moment and then display the measured weight for a
few seconds.
If you want to make a new measurement, get off the scale and go back up.
The scale will turn off automatically after a few seconds, thus prolonging
the life of the batteries.
MEASUREMENT OF PERCENTAGE BODY FAT, WATER, MUSCLE MASS,
BONE MASS, VISCUS FAT, CALORIE, BMI, VISCERAL FAT
The electrodes are located on the surface of the scale to measure the
percentage of body fat, water, muscle mass and bone mass. That is why it is
essential that during this measurement you remain barefoot. Before carrying
out the measurement you must first memorize the personal data (gender, age
and height), proceed as indicated below:
Saving of personal data
1. With the scale off, touch the SET selection control with the fingertip and the
display will flash the last selected memory position " P0 ... P9 ", with the
fingertip touch the selection controls ▲ or ▼ and choose the number of
desired memory (P0 ... P9).
2. Touch the SET selection control with the fingertip to access the genre
selection menu, the corresponding icon will flash.
3. Touch the ▲ or ▼ selection controls with your fingertip and choose the
gender, man ( ) or woman ( ).
4. Touch the SET selection control again with your fingertip and the display
will show the "Age" indication as well as the numeric digits flashing.
5

Publicidad

loading

Este manual también es adecuado para:

Mx-pb2450-1