Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
4. Attach top panel (A), shelf (I) and bottom panel (J) to
assembly. Secure in place with M4 x 35 mm screws (BB).
Hardware Used
BB
M4 x 35 mm Screw
5. Attach pole holders (FF) to metal pole (K), securing
with M4 x 15 mm bolts (EE).
Hardware Used
EE
M4 x 15 mm Bolt
FF
Pole holder
6. Attach pole holders (FF) to top frame (B), using 1/4 in. x
12 mm bolts (AA). Tighten with hex wrench (CC).
Hardware Used
AA
1/4 in. x 12 mm Bolt
CC
Hex wrench
4
I
J
x 22
BB
5
K
FF
x 2
x 2
K
6
x 4
x 1
AA
CC
AA
7
ASSEMBLY INSTRUCTIONS
7a. Adjust floor levelers to level the unit against the wall
where desired.
A
7b. Using top frame (B) as a template, mark one mount-
ing holes location on the wall. Drill one pilot holes into
the wall where previously marked. Make sure that the
drilled holes can fit for the wall anchors (sold sepa-
rately) properly. Press the anchors into the holes and
gently tap with a hammer until flush in the holes. If the
mounting hole coincides with a wooden stud, there is
E
no need wall anchor.
7c. Align top frame (B) and back crossers (GG) over the
drywall anchors (KK) and secure with M5 x 65 mm
screw (JJ). Tighten securely with phillips screwdriver.
Hardware Used
Back Crosser
GG
M5 x 65 mm
JJ
Screw
FF
KK
Drywall Anchor
8. If you buy more than one unit, you can collect more style.
EE
FF
9. Secure units together by attaching the metal
plates (II) with the 1/4 in. x 12 mm bolts (AA) into
B
the holes. Tighten with hex wrench (CC).
NOTE: Must install step 7 for all secured units.
Hardware Used
AA
1/4 in. x 12 mm Bolt
CC
Hex wrench
II
Metal plate
FF
7
KK
GG
B
JJ
x 1
8
x 1
x 1
9
x 6
x 1
AA
x 2
8
Wall
II
CC
Publicidad
