Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
The fan is for use on a nominal 120V circuit, and
should be connected to a grounding outlet that
looks like that illustrated in sketch a. A temporary
adaptor, which looks like the adaptor illustrated
in sketch b, may be used to connect this plug
to a 2-pole receptacle as shown in sketch b
if a properly grounded outlet is not available.
The temporary adaptor should be used only
until a properly grounded outlet can be installed
by a quali ed electrician. The green colored rigid
ear, lug, and the like, extending from the adaptor
must be connected to a permanent ground such
as a properly grounded outlet box cover.
Whenever the adaptor is used, it must be
held in place by the metal screw.
NOTE:
IN CANADA, THE USE OF A
TEMPORARY ADAPTOR IS NOT PERMITTED
BY THE CANADIAN ELECTRICAL CODE.
Ensure that the fan is connected to an outlet
GROUNDED
a
OUTLET
BOX
GROUNDING PIN
USE OF EXTENSION CORDS
WITH FAN
Only use a grounded extension cord that is rated
at least 15 amps and has a third-wire ground.
When a long extension cord is used to connect
the fan, a voltage drop occurs. The longer the
cord, the greater the voltage drop. This results
in less voltage being supplied to the fan and
increases the amount of current (amp) draw or
reduces performance. A heavier cord with a
larger wire size will reduce the voltage drop. Be
sure to choose a cord that will supply enough
voltage to operate the fan. The table below
indicates appropriate gauge for extension
cords.
Minimum Gauge for Extension Cord Sets
Total Length of Cord in Feet (meters)
Volts
25(7.6)
Ampere Rating
120V
240V
50(15.2)
More
Not More
Than
Than
6
0
6
10
10
12
4
b
ADAPTER
150(45.7)
50(15.2)
100(30.5)
300(91.4)
100(30.5)
200(61.0)
AWG
18
16
16
14
18
16
14
12
16
16
14
12
WARNING: Keep electrical cords in good
condition. Do not use worn, bare, or frayed
cords because they can cause electric shock.
WARNING: Operating equipment at low
voltage can cause it to overheat. Using an
excessively long extension cord can cause the
cord to overheat.
FAN OPERATION
WARNING:
Before assembling the fan, make sure all parts
are present. Compare parts with contents list.
If any part is missing or damaged, do not
attempt to assemble, install, or operate the
product. Contact customer service for
replacement parts. Unplug fan before
assembling any parts to it.
1.
Tools Required (Not Included):
#2 Phillips Screwdriver or Suitable Drill
Equipped with #2 Phillips Bit.
Fan Cradle Assembly:
2.
Simple assembly is required to use this fan.
1
4
2
3
Wheel
Washer
1
2
•
Put the
into the
, then thread the
2
3
into the
, align the threaded hole of the
1
and tighten the
.
3
Fan Location:
3.
Place the fan in an area in
the room that will provide the most effective
air circulation.
Fan Connection:
4.
120 volt A.C., 60Hz wall outlet. Be sure plug
cause overheating and damage to the plug
or fan.
Screw
Axle
3
4
3
,
4
Plug fan directly into
Publicidad
