Publicidad
Idiomas disponibles
Idiomas disponibles
1.
Remove the tube protection cap before installation (Fig.2A, 1).
2.
Loosen the wing knob (Fig.2A, 2).
3.
Align the installation hole on the pole saw attachment shaft with the arrow on the
power head shaft, and push the pole saw attachment shaft into the power head shaft
until you hear a "click" sound, which means that the pole saw attachment shaft is
mounted into place (Fig.2B, 1).
4.
Try to rotate or pull the shaft to ensure the installation is secure, if not, reassemble it again.
5.
Tighten the wing knob firmly (Fig.2B, 2).
Wing knob
2
1
Arrow
Installation hole
Fig.2A
5.2 CONNECT THE EXTENSION TUBE BETWEEN THE POLE SAW ATTACHMENT
AND THE POWER HEAD
Never attach or adjust any attachment while the power head is running or with
the battery installed. Failure to stop the motor and remove the battery may cause
serious personal injury.
Make sure the tool is firmly secured before operation. Failure to secure the
attachment and power head/extension pole as instructed above could result in
serious injury or death.
NOTE: Follow the process in the section "5.1 Connect the pole saw attachment to the
power head" to install the extension tube between the pole saw attachment and power
head (Fig. 3). Once assembled correctly, the pole saw attachment, extension tube, and
the power head should not separate when pulled. Always test the connection by pulling
on them. Repeat the steps above if the shaft can be separated.
Page 14-English
2
1
Fig.2B
GREEN MACHINE 62V CORDLESS POLE SAW ATTACHMENT
Power head
Pole saw attachment
Extension tube
Fig.3
5.3 REMOVE THE ATTACHMENT FROM THE POWER HEAD
Never attach or adjust any attachment while the power head is running or with
the battery installed. Failure to stop the motor and remove the battery may cause
serious personal injury.
1.
Stop the motor and remove the battery pack.
2.
Loosen the wing knob to release the shaft (Fig.4A).
3.
Press the shaft release button (Fig.4B, 1), then pull the attachment shaft or
extension tube out from the power head shaft and remove it (Fig.4B, 2).
Fig.4A
GREEN MACHINE 62V CORDLESS POLE SAW ATTACHMENT
1
2
Shaft release button
Fig.4B
Page 15-English
Publicidad
