Publicidad
Idiomas disponibles
Idiomas disponibles
Technical data
Code
Description
Voltage
Frequency
Current
Rated power
Maximum power
Capacity
Vacuuming pressure
Outflow pressure
Conductors
Noise level
Insulation
Tool Build Quality: Double insulation Thermal insulation on motor winding: Class F
WARNING
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
it should only be replaced by the manufacturer or at a
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
Before gaining access to the terminals all power sources should be disconnected.
WARNING
Power requirements
WARNING
Tools with double insulation are equipped with a polarized plug
(one prong is wider than the other). This plug will only fit in the right way into a
polarized outlet. If the plug cannot be introduced into the outlet, reverse the plug. If
it still doesn't fit, call a qualified electrician to install for you a polarized outlet. Do
not alter the plug in any way. Double insulation eliminates the need of both a
grounded third power cord with three prongs or a grounded power connection.
WARNING
When using an extension cable, verify the gauge is enough for the power that your product needs. A lower
gauge cable will cause voltage drop in the line, resulting in power loss and overheating. The following table shows the right
size to use depending on cable's length and the ampere capability shown in the tool's nameplate. When in doubt use the
next higher gauge.
Ampere
Capacity
from 0 A and up to 10 A
from 10 A and up to 13 A
from 13 A and up to 15 A
from 15 A and up to 20 A
WARNING
When operating power tools outdoors, use a
extension cable labeled "For Outdoors Use". These extensions are especially designed
for operating outdoors and reduce the risk of electric shock.
18 AWG x 2C with insulating temperature of 221 °F
Class II
Power Cord Grips used in this product: Type "Y".
Number of
Conductors
3 (one grounded)
* It is safe to use only if the extensions have a built-in artifact for over current protection.
AWG = American Wire Gauge. Reference: NMX-J-195-ANCE
ASP-5X
101523
Stainless steel wet / dry vac
127 V
60 Hz
8 A
1.4 Hp
4 Hp
5 gal
15.8 kPa (2.2 PSI)
13.8 kPa (2 PSI)
88 dBA
IP Grade
Authorized Service Center.
Extension gauge
from 5.9' to 49.2'
|
18 AWG( * )
16 AWG
14 AWG
8 AWG
grounded
IPX4
higher than 49.2'
16 AWG
14 AWG
12 AWG
6 AWG
ENGLISH
ENGLISH
3
Publicidad
