Hendi 860502 Manual Del Usuario página 8

Grounding installation
GB
This appliance is classified as protection class I and must be
connected to a protective ground. Grounding reduces the risk
of electric shock by providing an escape wire for the electric
current.
This appliance is fitted with a power cord with grounding plug
or electrical connections with grounding wire. The connections
must be properly installed and grounded.
Main parts of the product
(Fig.1 on page 4)
1. Lid
2. Soup pot
3. Water pot
4. Housing
Control panel
(Fig.2 on page 4)
1. Operating indication lamp
2. ON/ OFF Switch
3. Malfunction indication lamp
4. Temperature display
5. Temperature control buttons
Preparation before use
• Remove all protective packaging and wrapping.
• Check that the device is in good condition and with all ac-
cessories. In case of incomplete or damaged delivery, please
contact the supplier immediately. In this case, do not use the
device.
• Clean the accessories and the appliance before use (See ==>
Cleaning & Maintenance).
• Make sure the appliance is completely dry.
• Place the appliance on a horizontal, stable and heat resistant
surface that is safe against water splashes.
• Keep the packaging if you intend to store your appliance in
the future.
• Keep the user manual for future reference.
NOTE! Due to manufacturing residues, the appliance may emit
a light odor during the first few uses. This is normal and does
not indicate any defect or hazard. Make sure the appliance is
well ventilated.
Operating instructions
(Control panel: Fig.2 on page 4)
1. Fill the water pan with water up to the MAX (min. up to the
MIN) mark.
2. Fill the soup pot with soup not over the MAX mark.
3. Connect the soup kettle to power and press the ON/OFF
switch (2).
4. Once the soup kettle is switched on. Its default SET TEM
PERATURE is at 80°C.
5. You can adjust the SET TEMPERATURE by pressing the UP
and DOWN buttons (5) at the left side of the control panel.
6. The soup kettle is in operation. Before the soup reaches the
SET TEMPERATURE, both the SET TEMPERATURE and the
ACTUAL TEMPERATURE will be alternately displayed.
8
Overheating Protection
• If the water level in the water pot is too low, the red indication
lamp (3) will blink and the buzzer sounds.
• You should fill the water pan with water no further than to the
MAX mark and switch off the soup kettle.
Then you need to wait for a while until the temperature of the
soup kettle has dropped before switching on the soup kettle
again.
If the red indication lamp is on, but no buzzer alarms
• This is a signal that something is wrong inside the soup kettle,
the user should bring the soup kettle for service.
NOTE: the thermostat is adjustable from 65°C to 95°C by 1°C
increments. (Topic)
Cleaning & maintenance
• ATTENTION! Always disconnect the appliance from the pow-
er supply and cool down before storage, cleaning & mainte-
nance.
• Do not use water jet or steam cleaner for cleaning and do not
push the appliance under the water as the parts will get wet
and electric shock might be resulted.
• If the appliance is not kept in a good state of cleanliness, this
can adversely affect the life of the appliance and result in a
dangerous situation.
Cleaning
• Clean the cooled exterior surface with a cloth or sponge
slightly dampened with a mild soap solution.
• For reasons of hygiene, the appliance should be cleaned be-
fore and after use.
• Avoid water contacting the electrical components.
• Clean the inside of container with a non-abrasive detergent
and rinse with clean water.
• Clean and descale the boiler base at regular intervals (see
chapter "Descaling")
• No parts are dishwasher safe.
Maintenance
• Check the operation of the appliance regularly to prevent se-
rious accidents.
• If you see that the appliance is not working properly or that
there is a problem, stop using it, switch it off and contact the
supplier.
• All maintenance, installation and repair work must be car-
ried out by specialised and authorised technicians, or recom-
mended by the manufacturer.
Transportation and Storage
• Before storage, always make sure that the appliance has
been disconnected from the power supply and completely
cooled down.
• Store the appliance in a cool, clean and dry place.
• Never place heavy objects on the appliance as this could
damage it.
• Do not move the appliance while it is under operation. Dis-
connect the appliance from power supply when moving and
hold it at the bottom.