Viking RescYou PV9280 Instrucciones De Uso página 4

EN
11. Fold the outer section on the right side like
a fan so that the release unit is on top. Let
the release line and handle hang down the
bottom in the cover.
IMPORTANT: Make sure that the release line
and handle are free-hanging on the right
side from the buckle on the protective cover.
12. Close zipper. Close the hook and loop
fastener. Check that the release unit is visible
in the window.
13. Push zipper ends inside the cover, close the
push buttons to keep zipper ends inside the
cover.
14. Place the release line underneath the flaps
and the release handle in the holder.
4.4 REPLACING THE CO2-CYLINDER AND BOBBIN
– HALKEY ROBERTS
After use in freshwater dry the lifejacket. If the
lifejacket has been used in saltwater, it must be
rinsed with fresh water and then dried. Remove
any air in the lifejacket using the oral inflation
valve.
DISASSEMBLY
Please see figure 1 and 2 on page 43
Step 1:
Unpack or open the lifejacket so that the
inflator is visible. Remove the wide elastic band
from the cylinder and bobbin housing unit. Slide
the cylinder holder and O-ring (figure 2) down
so it is not holding on to the manifold nut.
Unscrew the cylinder from the inflator.
Step 2:
Remove gas CO2 cylinder by rotating cylinder
counter-clockwise and removing the cylinder
from holder and O-ring. Discard cylinder.
Step 3:
Remove the cap by turning counter-clockwise.
Step 4:
Remove the bobbin from the cap or housing
unit. Discard bobbin (yellow). Check the housing
to be sure it is clear and dry.
4
VIKING RESCYOU
™
PRO 1F V95000
® ®
PRIME LIFEJACKET (PV9280)
Note: The bobbin (yellow) body may remain in
the housing or in the cap assembly when
you remove the cap. The bobbin body must be
removed before rearming.
REARMING
Note: Rearming must follow the sequence
below.
Step 5:
A new bobbin must be used. New bobbin must
have been purchased within four (4) years. If the
bobbin purchase date is unknown, check the
date on the bobbin and replace it if it is more
than four (4) years.
Step 6:
IMPORTANT!
Bobbin (yellow) must be installed into the
housing (see figure 1), white side up, aligning
the slots on the bobbin with the ridges inside
the threaded housing. The bobbin will slide in
easily if installed correctly.
Step 7:
Install cap by screwing clockwise until it meets
the housing shoulder. Note: There should be no
gap between the cap and the housing shoulder.
Step 8:
Check that the new CO2 cylinder is intact and
not punctured.
Step 9:
Install a new cylinder by engaging the cylinder
threads with the inflator threads. Turn the
cylinder clockwise till a firm seal is achieved.
Attach the wide elastic band to the cylinder
and turn the elastic band half a turn. The elastic
band must resemble the number '8'. Then
attach the remaining elastic band to the bobbin
housing.
WARNING: Lifejacket will only inflate if the
cylinder is turned to a full stop.
Slide the O-ring and the cylinder holder onto the
holder and into the groove. Slide the cylinder
holder and O-ring over the cylinder. The cylinder
holder and O-ring assembly should be holding
the manifold nut.