Publicidad
Idiomas disponibles
Idiomas disponibles
Start-up
• Finally, push the motion detector
onto the wall bracket until the de-
vice latches in place.
Ensure that the device is seated
correctly. All latching points must
engage.
Take care not to pinch any wires
when pressing together.
Figure 11
• Restore the power supply by
switching the circuit breaker back
on.
Figure 12
Depending on the installation
location, it may be necessary to
open the water drain of the de-
vice. If condensation forms, it can
drain through the opening.
ON
• Pierce the breakout opening (I)
on the lower part of the mounting
plate using a pointed object (e.g.
screwdriver).
Figure 13
Carry out this process only when
the device is not connected to the
power supply!
• If necessary, release the latching
points via the latching lugs (E) (e.g.
using a screwdriver) and at the
same time pull the device off the
mounting plate.
• Place the motion detector back on
the mounting plate.
• Put the device back into operation.
8 Start-up
Please read this entire section
before starting to use the device.
First set up your Homematic IP
Access Point via the Homematic IP
app to enable operation of other
Homematic IP devices within your
system. For further information,
please refer to the Access Point
operating manual.
27
Publicidad
