Hart HPSI01 Manual Del Operador página 5

OPERATION
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a sec-
ond is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you
are assembling parts, making adjustments, cleaning,
or when not in use. Removing battery pack will prevent
accidental starting that could cause serious personal
injury.
WARNING:
Always wear eye protection with side shields marked
to comply with ANSI Z87.1. Failure to do so could re-
sult in objects being thrown into your eyes and other
possible serious injuries.
WARNING:
Do not use any attachments or accessories not rec-
ommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
WARNING:
Do not hold the soldering iron pen with your fingers
near any metal part of the tool. The tip of the tool
reaches working temperature within seconds. Always
assume that the soldering tip is hot. Touching a hot
soldering tip can result in serious personal injury.
WARNING:
Do not use or store the soldering iron near flammable
or combustible materials or liquids. These materials
may ignite when exposed to the high temperatures
created by the tip.
APPLICATIONS
You may use this product for the purposes listed below:
 Soldering circuits and electrical connections
 Soldering of jewelry, stained glass, and other crafts
WARNING:
Battery tools are always in operating condition. Place
the switch in the off position and remove the battery
pack when the product is not in use or when carrying
at your side.
INSTALLING/REMOVING BATTERY PACK
See Figure 2, page 7.
 Make sure the on/off button is in the off position.
 Insert the battery pack into the product as shown.
 Make sure the latch on the battery pack snaps into place
and the battery pack is secured in the product before
beginning operation.
 Depress the latch
For complete charging instructions, see the operator's
manuals for your battery pack and charger.
ON/OFF BUTTON
See Figure 3, page 7.
The LED indicator will light up when a charged battery pack
is installed and the button is turned to the on position. If the
indicator light is on, the tip is heating.
 Install the battery pack.
 Press the on/off button to turn the power on.
NOTE: The LED indicator blinks on and off until it reaches
the maximum operating temperature. Once the maximum
temperature is reached, the indicator will glow solid.
 Press the on/off button to turn the soldering iron off.
NOTE: The LED indicator will fade on and off slowly for 10
minutes while the tip cools. Do not touch the tip while the
LED indicator is solid or fading.
AUTOMATIC SHUT-OFF
After 10 minutes of operation, the unit will automatically
power down and the LED will fade on and off slowly. This
preserves the tip and prevents powering an unattended
tool. To restore power, press the on/off switch to turn the
unit back on.
5 – English
to remove the battery pack.