AXXAIR DC115-AM1 Instrucciones De Manejo página 22

ENGLISH
NOTE:
It is possible to mount two tool holders symmetrically in relation to the axis of rotation of
the machine. Check that the tool holders are mounted with locking screws facing
outwards.
This mounting balances machining loads which will result in a longer machine life
cycle and also less frequent changing of the HSS plate (longer servicing intervals).
It is also possible to install the facing tool holder and a chamfering tool holder, which
enables the two operations to be performed simultaneously.
Caution, the setting up of the chamfering tool holder is very important and must be
very precise (see 4.1). The chamfering cut depth remains 3 mm with the tool holder
at 45°, and 6 mm with the tool holder at 30°.
Screw reference 1
Chamfering cut depth
(tool travel)
- 22 -
330B Route de Portes les Valence
F-26800 ETOILE-SUR-RHONE
www.axxair.com