AXXAIR DC115-AM1 Instrucciones De Manejo página 24

ENGLISH
5.3 User instructions:
Choose the rotation speed A (it is preferable to start machining on position 2 on the
power tool), then the rotation speed B.
Check the direction of rotation (clockwise when the operator is standing at the back
of the machine).
Risk of tipping: According to the tube's length, the machine could tip
over. If necessary, hold the tube with appropriate means.
WARNING
 Using the rear handwheel, move the tool plate as far as possible
 Put the tube in the machine, then position it 2 or 3mm from the cutting edge of the
insert
 Tighten the tube with the tightening lever.
 Start the electric motor, then slowly turn the rear handwheel to bring the cutting
edge closer to the front face of the tube.
A
B
- 24 -
330B Route de Portes les Valence
F-26800 ETOILE-SUR-RHONE
www.axxair.com