MAGNAT SIGNATURE LOUDSPEAKERS AS A FRONT OR REAR LOUDSPEAKER
The front loudspeakers are positioned at ear height on the left and right as equidistant from the television as possible. The rear loudspeakers
are placed at ear height or a little above on the left and right besides or better behind the listening position. (Fig. 4)
MAGNAT SIGNATURE CENTER 93
The SIGNATURE CENTER 93 loudspeaker visually and acoustically ideally matches the other SIGNATURE 900 models. The loudspeaker
is placed immediately on or under the television set. Otherwise please adhere to the general recommendations outlined in the previous
chapters.
MAGNAT SIGNATURE SUB 930A
The SIGNATURE SUB 930A active subwoofer visually and acoustically ideally matches the other loudspeakers in the
SIGNATURE 900 series. Please refer to the separate operating instructions supplied with this product.
CONNECTING TO AN AV RECEIVER
Fig. 5 shows the connecting to an AV receiver. Please also refer to your receiver's/amplifier's instructions.
MAINTENANCE
The lacquered surface is best cleaned with a mild household cleaner. On no account use furniture polish or similar products on these
surfaces.
HOW TO AVOID DAMAGE TO YOUR VALUABLE SPEAKERS
All MAGNAT loudspeakers are designed and built for optimum sound reproduction with the tone controls in the central position – i.e. with
"linear" amplifier output. Turning up the bass and treble controls too far delivers more power to the woofers and/or tweeters, and at high
volumes this can actually destroy the speaker units!
If the output of your amplifier is significantly higher than the rated power handling capacity of your speakers extremely high volumes can
physically destroy your speakers. This doesn't actually happen often but you should be aware that it is possible.
Weak amplifiers with low output ratings can actually be more dangerous for your speakers at medium volumes because weak amplifiers
may overload much faster than powerful ones and this causes measurable and audible distortion, which is extremely dangerous to your
loudspeakers.
Always turn the volume down immediately as soon as you hear distortion! If you like listening to loud music make sure that your amplifier can
deliver at least as much power as the speakers' power-handling rating.
THE SOUND YOU CAN'T HEAR...
Amplifiers, tuners and CD players can all produce inaudible high-frequency signals – and this doesn't only apply to cheap products. If your
tweeters fail at low or medium volumes you should have a qualified technician check your system components for dangerous inaudible
signals.
SPECIFICATIONS
Configuration:
Power-handling capacity:
Impedance:
Frequency response:
Recommended amplifier output:
Efficiency (2.8V / 1m):
Dimensions (WxHxD):
Accessory:
Configuration:
Power-handling capacity:
Impedance:
Frequency response:
Recommended amplifier output:
Efficiency (2.8V / 1m):
Dimensions (WxHxD):
Subject to technical change.
Signature 905
3,5 way bass reflex
190 / 340 watts
4 – 8 ohms
23 – 55 000 Hz
> 30 watts
92 dB
300 x 1060 x 370 mm
Metal spikes
Rubber spikes
Signature 903
3 way bass reflex
120 / 180 watts
4 – 8 ohms
30 – 55 000 Hz
> 20 watts
91 dB
225 x 370 x 352 mm
7
Signature 909
4 way bass reflex
280 / 500 watts
4 – 8 ohms
22 – 55 000 Hz
> 30 watts
93 dB
335 x 1225 x 490 mm
Metal spikes
Rubber spikes
Signature Center 93
3 way bass reflex
140 / 200 watts
4 – 8 ohms
32 – 55 000 Hz
> 20 watts
91 dB
570 x 215 x 350 mm