Publicidad
Idiomas disponibles
Idiomas disponibles
Making the Electrical
Connections
Remember
to disconnect the power.
Follow the steps below to connect the fan to your
household wiring. Use the wire connecting nuts
supplied with your fan. Secure the connectors
with electrical tape. Make sure there are no loose
strands or connections.
Step 1. Connect the fan supply (black) wire and
light supply (blue) wire to the black household
supply wire as shown in Figure 11.
Step 2. Connect the netura fan (white) wire to the
white netura household wire.
Step 3. Connect the fan ground wire (green) to
the household ground wire.
Step 4. After connecting the wires, spread them
apart so that the green and white wires are on one
side of the outlet box and the black and the blue
wires are on the other side.
Step 5. Turn the connecting nuts upward and
push the wiring into the outlet box. Figures 12
and 14 illustrate the wiring connections for
optional wall control (available at your Hampton
Bay Retailer, the wire color out of wall control
may vary, see wall control's installation manual
for correct wire connections.)
6.Make the Electric Connections
NOTE
LIGHT KITS ARE AVAILABLE AT YOU
HAMPTON BAY RETAILER. THE FAN IS
ALREADY WIRED TO SUPPORT THE LIGHT KIT
OPTION.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK,
OR OTHER PERSONAL INJURY. MOUNT FAN ONLY
ON AN OUTLET BOX OR SUPPORTING SYSTEM
MARKED ACCEPTABLE FOR FAN SUPPORT.
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK. DO NOT USE THIS FAN WITH ANY SOLID-
STATE SPEED CONTROL DEVICE.
SUPPLY CIRCUIT
Ground
Conductor
Outlet Box
Green
Ground
Lead
Ground to
Downrod
WHITE
BLUE
BLACK
WHITE
Figure 11
Diagram indicates optional light kit wiring.
Publicidad
