Publicidad
Idiomas disponibles
Idiomas disponibles
Hanging the fan
REMEMBER to turn off the power.Follow the
steps below to hang your fan properly.
NOTE:The ceiling fan is supplied with two
types of hanging assemblies;the standard
ceiling installation using the downrod with ball
t h e "
a n d s o c k e t , a n d
c l o s e - t o - c e i l i n g "
i n s t a l l a t i o n . T h e " c l o s e - t o - c e i l i n g "
installation is recommended in rooms with less
than 7-feet ceilings or in areas where additional
space is desired from the floor to the fan
blades.When using the standard downrod
installation,the distance from the ceiling to the
bottom of the fan blades will be approximately
12 inches for the 4½-inch downrod.The
" close-to-ceiling" installation reduces this
distance to 8½-inches.Once you have decided
which ceiling installation you will use,proceed
w i t h t h e f o l l o w i n g i n s t r u c t i o n s . W h e r e
n e c e s s a r y , e a c h s e c t i o n o f t h e
instructions.Where necessary,each section of
t h e i n s t r u c t i o n s w i l l n o t e t h e d i f f e r e n t
procedures to follow for the two types of
installation.
STANDARD CEILING INSTALLATION
1. Remove the mounting bracket from the by
loosening the four screws on the top of the
canopy.Remove the two non-slotted screws and
loosen the slotted screws.This will enable you
to remove the mounting bracket.
2. Place the downrod assembly through the
ceiling canopy and collar cover, then insert the
motor wires through the downrod assembly
(Figure5).
4.Installing Your Fan
Motor wires
Ceiling Canopy
Downrod
Figure 5
Hanger
Figure 6
Figure 7
3. Remove the pivot pin and split pin from
downrod. Slip downrod into motor collar, align
holes and re-install pivot pin and split pin.
(Figure 6).Secure the pivot pin by inserting the
split pin and bending ends to prevent it from
falling out of the holes(Figure7a).
4. Secure the hanger and downrod by tightening
the two screws on the hanger (Figure7a).
Lead wires
Ball/downrod
assembly
Downrod
Split Pin
Ceiling
canopy
Pivot Pin
Screws
Split pin
Tighten
screws
firmly
Ceiling
mounting
plate
Figure 7a
Ceiling
canopy
Canopy
cover
Pin in
locked
position
Collar cover
Pivot pin
Motor collar
Publicidad
