Descargar Imprimir esta página

HAMPTON BAY CF552A-H21 Manual De Instrucciones página 9

Ventilador de techo 52

Publicidad

Idiomas disponibles

Idiomas disponibles

C L O S E - T O - C E I L I N G
INSTALLATION
1. Remove the mounting bracket from the
canopy by loosening the 4 screws on the
top of the canopy.Remove the two non
slotted screws and loosen the slotted
screws.This will enable you to remove the
mounting bracket.
2. Remove the decorative canopy bottom
cover from the canopy (Figure 7).
3. Mount the ceiling canopy to the hanger
by the three screws and spring washers
from the loose parts bag containing(d)
(Figure 8).
WARNING
FAILURE TO COMPLETELY TIGHTEN
THE THREE SCREWS AND SPRING
WASHERS IN STEP 4 COULD RESULT
IN FAN LOOSENING AND POSSIBLY
Hanger
Ceiling canopy
Figure 8
Installing Fan to the
Electrical Box
1. Pass the 120-volt supply wires through
the center hole in the mounting bracket as
shown in Figure9.
2. Attach the mounting bracket on the
electrical box by screws provided with the
outlet box.When using close-to-ceiling
m o u n t i n g , i t i s i m p o r t a n t t h a t t h e
m o u n t i n g b r a c k e t b e l e v e l . I f
n e c e s s a r y , u s e l e v e l i n g w a s h e r s ( n o t
included) between the mounting bracket
and electrical box.Note that the flat side
of the mounting bracket is to be toward
the electrical box(Figure 9).
UL Listed
electrical
box
Ceiling
mounting
plate
Screw and
Hook
Lockwasher
Figure 9
Washers
Mounting
screws
120V Wires
(supplied with
electrical box)
Installing Your Fan 5.
WARNING
WHEN MOUNTING ON A SLOPED
CEILING.THE STANDARD
BALL/DOWNROD MOUNTING METHOD
MUST BE USED.MAKE SURE THE
MOUNTING BRACKET SLOTS ARE ON
THE LORER SIDE BY SLIDING THE
MOUNTING BRACKET FROM THE TOP
3. Securely tighten the two mounting screws.
4. Carefully lift the fan assembly up to the
mounting bracket.If using close-to-ceiling
mounting,hang the fan on the hook provided by
utilizing one of the holes at the outer rim of the
ceiling canopy.If using standard mounting,seat
the hanger ball in the mounting bracket socket.
Make sure the tab on the mounting bracket
socket is properly seated in the groove in the
hanger ball.(Figure 10).
close-to-Ceiling
Standard Mounting
Mounting
Figure 10

Publicidad

loading

Este manual también es adecuado para:

82598