Publicidad
Idiomas disponibles
Idiomas disponibles
Housing
Light Kit
8.
Decorative
Screws(3)
Hole
Thread Rod
Fabric
Shade
BLADE BALANCING
All blades are grouped by weight. Because nat-
ural woods vary in density, the fan may wobble
even though the blades are weight matched.
The following procedure should correct most
Tilt 45°
fan wobble. Check after each step.
1. Check that all blade and blade brackets are
Figure 12
secure.
2. Most fan wobble problems are caused when
blade levels are unequal. Check this level by
selecting a point on the ceiling above the tip
of one of the blades. Measure from a point
on the center of each blade to the point on
the ceiling. Measure this distance as shown
in Figure 14. Rotate the fan until the next
blade is positioned for measurement. Re-
peat for each blade. Measurement devia-
tions should be within 1/8". Run the fan for
10 minutes.
3. Use the enclosed Bladed Balancing Kit if
the blade wobble is still noticeable.
Figure 13
TO REDUCE THE RISK OF PERSONAL INJURY,
DO NOT BEND THE BLADE HOLDERS WHILE
INSTALLING, BALANCING THE BLADES, OR
CLEANING THE FAN. DO NOT INSERT FOREIGN
OBJECTS BETWEEN ROTATING BLADES.
Figure 14
Publicidad
