Publicidad
Idiomas disponibles
Idiomas disponibles
Outlet Box
Installing Fan to
the Outlet Box
Outlet Box)
WHEN MOUNTING THE FAN ON A SLOPED
CEILING, THE STANDARD BALL/DOWNROD
MOUNTING METHOD MUST BE USED. THE
MOUNTING PLATE MUST BE MOUNTED SO
THAT THE SLOT OPENINGS ARE ON THE
LOWER SIDE BY SLIDING THE MOUNTING
PLATE FROM THE TOP DOWN.
1. Pass the 120-volt supply wires through the
center hole in the ceiling mounting plate as
shown in Figure 7.
2. Install the ceiling mounting plate on the
outlet box by sliding the mounting plate
over the two screws provided with the
outlet box (Figure 7). If necessary, use
leveling washers (not included) between the
mounting plate and the outlet box. Note that
the flat side of the mounting plate is toward
the outlet box (Figure 7).
3. Securely tighten the two mounting screws.
4. Carefully lift the assembly up to the ceiling
mounting plate. Make sure the tab on
Figure 7
the mounting plate is properly seated in
the groove in the hanger ball.
Making the Electrical
Connections
REMEMBER to disconnect the power. If
you feel you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
Follow the steps below or follow the instructions
included along with the remote control to connect
the fan to your household wiring. Use the wire
connecting nuts supplied with your fan. Se-
cure the connectors with electrical tape.
Make sure there are no loose strands or
connections (Figure 8).
1. Connect the ground conductor of the 120v
supply (this may be a bare wire or a wire
with green colored insulation) to the green
ground lead(s) of the fan.
2. Connect the fan motor white wire to the re-
ceiver white wire using a wire nut.
3. Connect the fan motor black wire to the re-
ceiver black wire using a wire nut.
4. Connect the fan motor blue wire to the re-
ceiver blue wire using a wire nut.
5. Connect the receiver black wire (or red)
wire to the supply black (hot) wire using a
wire nut.
6. Connect the receiver white wire to the sup-
ply white (neutral) wire using a wire nut.
5.
Publicidad
