Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING & WARRANTY
Troubleshoot your problem by using the chart below. If the dehumidifier still does
not work properly, contact BLACK+DECKER customer service center or the nearest
authorized service center.
WARNING: Users must never troubleshoot internal components.
TROUBLE
Appliance does not
turn on
LCD Screen is illuminated
with AUTO indicated,
but no mist is being
produced
Humidifier shuts off
Power on light is on but
humidifier is not operating
The mist has an odor
The volume of mist is low
Humidifier is noisy
Humidifier produces white
dust
Film or scale in water tank
POSSIBLE CAUSE
Appliance is not plugged in
The humidifier has reached the
set RH% so it will stop producing
mist
No water is in water tank
Too much water is in water tank
The unit is new
The water may not be clean or
has become stagnant from sitting
too long
There is mineral scale in the water
The water may not be clean or
has become stagnant from sitting
too long
There is a vibrating sound coming
from the water tank because the
water level is too low
The humidifier is not on a flat
surface
Hard Water/Minerals in the water
Hard Water/Minerals in the water
Unit Dimensions (WxDxH): 9.84'' x 7.28'' x 14''
POSSIBLE REMEDY
Check that the appliance is plugged into a
working outlet
The humidifier will produce mist again
automatically to maintain the RH%. If you
would like the humidifier to continue to
produce mist, either increase the RH% or
continue to press the HUMIDITY button
until Co flashes on the LCD screen and
AUTO is no longer indicated. You can
adjust mist using the MAX/MIN button
When the tank is empty the humidifier
will shut off automatically. Refill the water
tank with water. Turn the humidifier ON
by pressing the ON/OFF button.
Remove water from the water tank
Remove water tank and open cover. Let it
sit in cool environment for 12 hours
Clean the water tank/transducer and fill
with clean water.
*Refer to CLEANING AND MAINTENANCE
section of this manual.
Clean the water tank/transducer and fill
with clean water
*Refer to CLEANING AND MAINTENANCE
section of this manual.
Clean the water tank/transducer and fill
with clean water
*Refer to CLEANING AND MAINTENANCE
section of this manual.
Fill the water tank with more water
Move the humidifier to a stable flat surface
Some white dust is normal. It is caused
by the mineral content in the water which
creates white dust when released into
the air. To reduce white dust you can use
distilled water.
Clean the water tank/transducer and fill
with clean water
*Refer to CLEANING AND MAINTENANCE
section of this manual.
SPECIFICATIONS
Voltage: 120V, 60Hz
Net Weight: Approx. 5.3 lbs
ENGLISH
Page 13
Publicidad
