Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
SET UP & USE
LCD IMAGE
Empty Tank
Timer
Indicator
NOTE: If the humidifier stops producing mist when AUTO is shown on the LCD screen,
it has reached the set RH%. The humidifier will produce mist again automatically
to maintain the RH%. If you would like the humidifier to continue to produce
mist, either increase the RH% or continue to press the HUMIDITY button until
Co flashes on the LCD screen and AUTO is no longer indicated. You can adjust
mist using the MAX/MIN button.
-ION: Press the
deactivate. The -ion symbol will illuminate on the LCD screen.
NOTE: If you press and hold the
lights in the circles surrounding the LCD screen. Pressing and holding for
another 2 seconds will turn these lights back on again.
MAX/MIN: Pressing the
and 3 (HIGH) speeds. The selected number will show on the bottom of
the LCD screen.
HUMIDITY: When this button is pressed it allows you to select a target humidity
Page 8
Timer
-ION button to generate negative ions. Press the button again to
MAX/MIN button will select between 1 (LOW), 2 (MEDIUM)
level from 45% RH to 90% RH. Continue to press the button to add 5%
RH every time you press it until you reach a maximum of 90% RH. If you
press this button again you will reach Co% (Continue Operation). You
will then need to continue to scroll starting at 45% RH again until you
reach the RH% you would like to set.
The AUTO light will blink as you scroll through the target RH%
selections. A steady AUTO light indicates the actual RH% in the room.
The humidifier will stop producing mist when the target RH% is
achieved and resume automatically to maintain the selected RH%.
- Ion
Auto
%RH
Speed
-ION button for 2 seconds it will turn off the blue
Auto
Relative
Humidity
Publicidad
