Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP & USE
OPERATING INSTRUCTIONS
Remove the humidifier from the packing carton and place it upright on an level
surface.
NOTE: Only operate humidifier in upright position. Always make sure the water tank
is clean. Fill with cool water.
1. Remove the water tank from the humidifier base. Remove the cap by turning it
counterclockwise. Fill the entire tank with clean, cool water. After filling with fresh,
distilled, or demineralized water make sure the cap is tightened and water tank is
securely in place over the base of the unit.
Please note the mist outlet might fall out of its position and it should be replaced
prior to operating the humidifier.
CAUTION:
Do not move the humidifier after the humidifier has been filled with water.
This can cause too much water to spill into the humidifier base.
Only add water to the tank through the opening with the cap. Do not
add directly to the base or the mist outlet.
2. Connect the power plug. The LCD screen will display the current RH% (relative
humidity) in the air.
3. ON/OFF: Turn the humidifier ON by pressing the ON/OFF button The humidifier
will begin to operate. You can then select from other options on the control panel.
Turn the humidifier OFF at any time by pressing the ON/OFF button again.
NOTE: When the tank is empty the humidifier will shut off automatically. Once the
tank is refilled with water turn the humidifier ON by pressing the ON/OFF
button.
CONTROL PANEL
ENGLISH
Page 7
Publicidad
