GE 20 Manual Del Propietario E Instalación página 17

Installation Instructions
1_] REMOVE THE FRESH FOOD
DOOR HANDLE
(For placement in the installation location
or reversal of the handles - on some
models)
Stainless steel (on
some models):
O REMOVING
THE DOOR
HANDLE: Loosen
the set screws
with the 3/32"
Allen wrench
and remove
the handle.
NOTE: For
Double Door
models follow
the same
procedure on
the opposite door.
1
Badge
Mounting J
Fasteners
(appearance may vary)
Plastic handle
(on some models}:
O REMOVING THE DOOR HANDLE: Depress the
tab on the underside of the handle and slide
the handle up and off of the mounting
fasteners.
O
REVERSING THE _-t
DOOR HANDLE
(on some
models):
, Remove
the handle
mounting
fasteners with
a 3/16" Allen
wrench and
transfer
the handle
mounting
fasteners to
the right side.
Haunting
Fasteners
(appearance may vary)
f
Badge
, Remove the logo badge.
, Remove and transfer the plug button to
the left side of the fresh food door. NOTE:
Use a flat plastic edge to prevent
damaging the door. Remove any adhesive
on the door with a mild detergent. Remove
the paper covering on the adhesive
backing on the logo badge prior to carefully
attaching the badge to the door.
FTI REMOVE THE FREEZER DOOR HANDLE
Stainless steel and plastic handles:
0 Loosen the set screws located on the
underside of the handle with the 1/8" Allen
wrench and remove the handle.
NOTE: If the handle mounting fasteners need
to be tightened or removed, use a 3/16" Allen
wrench.
17