GE 20 Manual Del Propietario E Instalación página 25

Installation Instructions
E] REHANG REFRIGERATOR DOOR
r_ Lower the refrigerator door onto the center hinge
pin. Ensure that the plastic hinge pin thimble is on
the center hinge pin or inside door hinge pin hole
located in the bottom of the door.
r_ Insert the door thimble into the hinge hole
on top of the refrigerator door and then
insert the top hinge pin. Make sure the door
is aligned with the cabinet. Attach the hinge
to the top of the cabinet loosely with the bolts.
_] Make sure the gasket on the door is flush against
the cabinet and is not folded. Support the door on
the handle side and make sure the door is straight
and the gap between the doors is even across the
front. While holding the door in place, tighten the
top hinge bolts. Replace the hinge cover.
INSTALL THE LOGO BADGE
Remove the adhesive backing paper
and align the pins on the back of the badge
with the holes in the door. Apply pressure to
the badge to ensure it sticks to the door.
25
REMOVING THE DOORS
(Double Door Refrigerator Models only)
IMPORTANT NOTES
NOTE: Door swing is not reversible.
, Read the instructions all the way through before
starting.
, Handle parts carefully to avoid scratching paint.
, Set screws down by their related parts to avoid
using them in the wrong places.
, Provide a non-scratching work surface for
the doors.
IMPORTANT: Once you begin, do not move
the cabinet.
These instructions ore for removing the doors.
Unplug the refrigerator from its electricol outlet.
Empty oil door shelves, including the doiry
comportment.
TOOLS YOU WILL NEED
Adjustable Wrench 3/8rl and !0 mm Socket
Ratchet/Driver
Masking Tape
Thin-blade Screwdriver
Phillips Screwdriver