Publicidad
Idiomas disponibles
Idiomas disponibles
Preparing your baby monitor
EN
+
+
+
+
+
+
+
+
10
Parent unit
1 Open the battery compartment by sliding the cover (B-11)
downwards.
2 Insert the two 1.2V AAA size Ni-MH rechargeable batteries
(supplied), noting the + and – configuration inside the battery
compartment.
3 Put the battery compartment cover (B-11) back in place.
Close the compartment by sliding the cover (B-11) upward
until it clicks in position.
4 Connect the AC power adapter (B-13) of the charging base
(B-14) to a wall outlet.
5 Place the parent unit in the charging base (B-14).
> The POWER light (B-15) lights up red.
6 Leave the parent unit in the charging base until the batteries
are fully charged (at least 16 hours).
> The POWER light (B-15) will stay red, even when batteries
are fully charged.
> When the batteries are fully charged, the parent unit can be
taken out of the charging base and used cordlessly for at
least 8 hours.
Notes:
– Operation time will be 8 hours based on the assumption that
the baby unit will be transmitting 25% of the time and is in
standby mode for the rest of the time (baby does not any
make sound).
– When the parent unit batteries are charged for the first time,
operating time will be less than 8 hours.The batteries will use
their maximum capacity after at least four times charging and
discharging.
Publicidad
