OPERATING INSTRUCTIONS
OFF
• Push the power button to turn the unit on (Green power light will
turn on). The unit will turn on for 1 - 2 seconds and shut off. This
is a normal function of the auto start feature.
• Squeeze the spray gun trigger to begin pressure washing.
• Begin power washing by squeezing the trigger on the spray gun
all the way into the handle.
• Release the spray gun trigger to stop the power washer.
• Allow the motor to come to a complete stop before squeezing
the trigger again.
• Squeezing rapidly will cause the auto start feature to miss an
on/off cycle that may prevent it from turning on while squeezing
trigger after rapid squeezing. Use slow, deliberate trigger pulls
to avoid this.
• Always test a small area to avoid chance of
damaging the surface.
bepowerequipment.com
ON
Adjusting Soap Levels on Foam Cannon
Twist knob to adjust the level of soap as indicated on
the top of the Foam Cannon (O). Twist toward the
higher concentration of bubbles for more soap, or the
opposite direction for less.
• The power washer will pull a ratio of water to detergent
of 10:1 or 10 parts water to 1 part detergent. The
detergent concentration can be adjusted by turning the
detergent knob on the top of the machine. Turn it left for
more concentration or turn it right for less concentration.
*I
O
13