Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
2
Removing Power Washer Unit from Frame for
Handheld Operation
• Locate latches on the lower side of frame. Unlock
latches by pulling downward on the latches. Place
a foot on the pad at the front of the lower frame and
then lift the power washer unit off the frame.
Operation Tips
• Note: Test the GFCI (For US unit only) before each use:
1. Plug GFCI into power outlet. Indicator should turn
green to show that cord has power.
2. Press test button, green indicator should turn off to
verify that GFCI cut off power to the cord.
3. Press reset button – green indicator should turn on to
show that cord has power again.
4. When GFCI is working properly, green indicator will
turn on when power is applied. If gree
turns off, it has detected electric leakage and the
GFCI cut off power to the appliance.
14
3
n indicator
• If you hear the motor run intermittently when the trigger is
not being squeezed, that is normal.
The pump is priming itself so it is ready to operate when
the trigger is squeezed. Turn off the power washer if not
being used after five minutes.
• The o-rings on the bayonet end of the nozzle should be
cleaned regularly and lubricated with non-water soluble
grease such as petroleum jelly (not included).
• Keep the nozzle cleaning wire for use in unclogging the
nozzle. If you lose the cleaning wire, a straightened paper
clip also works.
How to Avoid Damaging Surfaces
• Damage to surfaces being cleaned occurs because the
impact force of the water pressure exceeds the durability
of the surface. Bare wood can be penetrated, paint can
be peeled off, etc. You can vary the force of your power
washer by controlling:
1. The angle of the surface being cleaned.
2. The distance of the nozzle from the surface being
cleaned.
• Never use a narrow high pressure stream of water on
soft surfaces susceptible to damage.
• Use the 25˚ quick connect nozzle when cleaning
windows. Squeeze the trigger and vary the spray pattern
and angle until optimum cleaning efficiency is achieved.
Using Power Cord
• Remove the power cord from the unit by swiveling the
cord hook to the right or left. The power cord then can be
slid off to either side of the power washer unit.
• Swivel cord hook back to center when ready to wrap the
cord back into place for storage.
bepowerequipment.com
Publicidad
