Charging The Battery - Bruder Mannesmann Werkzeuge 17050 Manual De Instrucciones

Charger:
Pri.: 100-240V~ 50/60 Hz
Sec.: 5,5 V = / 500 mA
Always wear eye protection during use!
Vibration data
• The vibration emission level given in this information sheet has been measured in accordance with a
standardized test given in EN 60745 and may be used to compare one tool with another.
• The vibration emission level will vary because of the ways in which a power tool can be used and may
increase above the level given in this information sheet. This could lead to a significant underestimate of
exposure when the tool is used regularly in such a way.
• Note: To be accurate, an estimation of the level of exposure to vibration experienced during a given period of
work should also take into account the times when the tool is switched off and when it is running but not
actually doing the job. This may significantly reduce the exposure level over the total working period.
Suitable nails and staples:
You can use staples with a length of 4-10 mm or nails with a length of 10 mm (e.g. Brüder Mannesmann item-no.
48413) with this cordless staple gun.
Staples - RB 11,3 Staples - RB 10,6
Bosch Typ 53 Bosch Typ 57
KWB Typ 053 KWB Typ 057
Novus A Novus G
Prebena Typ VX Prebena Typ PF
Rapid Nr. 3/53/530 Rapid No. 4/11/140
LUX 40-43 LUX 80-82
Loading of staples (Fig. 2) or nails (Fig. 3)
•
Push the staple feeder catch (5) at the back of the tool towards the magazine, and pull out the staple feeder.
Warning: Once the staple or nail strip has been placed in the feeder, it will be spring-loaded. Hold the catch
firmly to prevent the feeder from suddenly being ejecting from the tool.
•
Place the staple strip (Fig. 2) or nail strip (Fig. 3) into the magazine.
•
Place the nail strip on that side of the magazine, which is marked with the according symbol (Fig.3)
•
Push the staple feeder back to the front and secure by hitching the catch (5) behind the opening in the
housing.

Charging the battery

•
Before being used for the first time, the electric screwdriver must be charged.
•
Only use the provided charger to charge the battery..
•
Only use the battery charger in enclosed areas, and do not use in rain or high humidity.
•
Should the housing of the battery charger appear damaged, remove this from the electrical socket, check it
and if necessary get it repaired.
•
Only charge the battery at an ambient temperature between 10˚-40˚C.
•
Only connect the battery charger (6) to a 230 V AC power socket using the charging socket (4).
•
The battery should only be charged for 2-3 hours. Overcharging the battery (for longer than 4 hours) can
damage the battery cells and the battery charger.
GB - 8