Publicidad
Idiomas disponibles
Idiomas disponibles
c. Continue pressing TARE(→) until display shows "Fn9".
d. Press MODE(ENT) to enter, and display shows "Sd.on".
e. Press ZERO(↑) to select between "Sd.on" or "Sd.oFF".
f. Press MODE(ENT) to confirm and exit the current function, display shows "Fn10".
g. Press MODE(ENT) to enter the next function, or press ZERO(↑) to exit. When ZERO(↑) is
pressed, display will show "SAVE" if setting was changed, user can either press MODE(ENT) for
yes to save the changes made or press ZERO(↑) for not to save the changes.
4.11 Automatic/Continuous Tare [Fn10]
Under this function, user can enable or disable auto tare function of the first weight, or
the consecutive loads place on the platter. a. Scale is off
b. Press and hold TARE(→) and press ON/OFF, display shows "Fn1"
c. Continue pressing TARE(→) until display shows "Fn10".
d. Press MODE(ENT) to enter, and display shows "tr.oFF"
e. Press ZERO(↑) to select "tr.on", "tr.Cnt" or "tr.oFF"
f. Press MODE(ENT) to confirm and exit the current function, display shows "Fn11".
Press MODE(ENT) to enter the next function, or press ZERO(↑) to exit. When ZERO(↑) is pressed,
display will show "SAVE" if setting was changed, user can either press MODE(ENT) for yes to save
the changes made or press ZERO(↑) for not to save the changes.
4.12 Transmission Protocol Through RS232 [Fn11]
Under this function, user can select the transmission interface, speed, mode and format for RS-
232 and also the communication protocol. a. Scale is off
b. Press and hold TARE(→) and press ON/OFF, display shows "Fn1".
c. Continue pressing TARE(→) until display shows "Fn11".
When display shows "Fn11", press MODE(ENT) to enter the function
First level selection:
Second level selection: bAUd / ForMt / trAnS / ProtL
Selection under bAud: 2400 / 4800 / 9600 / 19200 / 38400 / 115200bps
Selection under ProtL: n.8.1 / E.7.1 / o.7.1 / E.8.1
Selection under trAnS: MAnU / Auto / StrM
Selection under ForMt: SEr.1 / SEr.2
nonE / rS232
16
Publicidad
