Ir Receiver Unit (Optional Parts); Drain Pump Unit (Optional Parts); Field Setting; Setting The Address - Fujitsu Airstage ARXB07GALH Manual De Instalación

6.8. IR receiver unit (Optional parts)

• For the installation method, please refer to the INSTALLATION MANUAL of IR receiver
unit.
Connection methods
• Connection terminals
Controller PCB
• Wiring arrangement
Note (*): Remove the mounted cover, and mount the one touch bushing (Accessory).

6.9. Drain pump unit (Optional parts)

• For the installation method, please refer to the INSTALLATION MANUAL of drain pump
unit.
Connection methods
• Connection terminals
Power supply PCB
En-15
9374342280-01_IM.indb Sec1:15 9374342280-01_IM.indb Sec1:15
IR receiver unit
terminal (CN18)
Core
Controller PCB
Cable tie
One touch bushing
(Field supply)
(Accessories)*
Controller PCB
Flort switch
terminal (CNA05)
Drain pump
terminal (CN106)
• Wiring arrangement
Cable tie
(Field supply)
Note (*): Remove the mounted cover, and mount the one touch bushing (Accessory).

7. FIELD SETTING

There are 3 methods for address setting by FIELD SETTING as follows.
Set by either of the methods.
Each setting method is described (1) to (3) below.
(1) IU AD, REF AD SW settings....This section (7.1. Setting the address)
(2) Remote controller settings ............... Refer to the wired or wireless remote controller
manual for detailed setting information. (Set IU
AD, REF AD SW to 0)
(3) Automatic address settings ............. Refer to the outdoor unit manual for detailed
setting information. (Set IU AD, REF AD SW to 0)
CAUTION
Be sure to turn OFF the power before performing the fi eld setting.

7.1. Setting the address

Manual address setting method
• If the receiver unit is attached, the indoor unit address and the refrigerant circuit
address can also be set up through the wireless remote controller.
CAUTION
Use an insulated screwdriver to set the DIP switches.
Rotary switch
Example: "0"
Setting
Setting
range
Setting
Indoor unit address 0 to 63 example
Setting
Refrigerant circuit
0 to 99 example
address
Controller PCB
One touch bushing
(Accessories)*
Rotary switch
Example: "0"
Type of switch
2
IU AD × 10 IU AD × 1
63
REF AD × 10 REF AD × 1
7/12/2012 10:43:27 AM 7/12/2012 10:43:27 AM