Publicidad
Idiomas disponibles
Idiomas disponibles
EN
NOTE: Shim and moving blade can be replaced independently. When doing so, don't be afraid of too small a blade opening. After electricity, the normal aperture
size will automatically recover.
Pruner maintenance:
1. Do not cut the branch outside the cutting range; do not cut non-plant materials such as metal and stone etc. Do not use a vice
to hold tools. Replace a shear blade if it is worn or damaged.
2. Keep the equipment clean, wipe the pruner, batteries and chargers with a clean cloth (do not use corrosive detergents or
solvents) and use a soft brush or dry cloth to remove dust.
3. Do not immerse pruner, batteries, and chargers in water or other liquids.
4. Use the equipment correctly. Stop using them when there is any damage to the pruner, batteries, chargers, etc.
5. If the power switch does not work normally or the pruning shears cannot be turned off, do not use them. They will be dangerous
to control without a switch and must be repaired.
6. Make sure the switch is off when replacing accessories or storing pruning shears. Such a preventive measure will reduce the
risk of accidentally turning on the pruner.
7. Close the blades of the pruner and keep them out of the reach of children. It is dangerous to allow inexperienced people and
untrained users to use them.
8. When using pruner, respect the tools and use, and consider the work environment and tasks. It can pose a risk if pruner is
used for irregular operation.
9. After use, remove the dirt from the blades, add lubricating oil or motor oil to the contact part, make the blade keep in the normal
maintenance state, and reduce and extend the life of the blade for the next use .
6
6
Publicidad
