Publicidad
Idiomas disponibles
Idiomas disponibles
4.3 • Attach the handles
1.
Refer to Figure 2 and figure 6.
Slot the RHS handle tube into the RHS tube of the main frame.
2.
Push and hold the handle button-clip, then push the handle until the button-
clip clicks into position in the first hole.
3.
Adjust the height of the handle to the correct height. The handle position
should line up with your wrists, in a standing position, with your arms relaxed
by your side.
4.
Make sure that the thumb support on the handle is facing the internal side of
the rollator.
Note : The range of the handle adjustment is in 0.98 inches increments, from
32.3inches to 36.2 inches.
5.
To adjust the handle, push and hold the button-clip, then lower to the required
height. Allow the button-clip to click into the nearest adjustment hole to secure.
Note: make sure that the button-clip has fully engaged into the hole.
6.
Repeat for the other handle.
7.
Attach the brake cables.
Refer to Figure 7.
4.4 • Fitting the Bag
1.
Refer to Figure 8.
Slot one of the 'T-brackets' on the side of the bag into the slot at the top of
the main frame.
Note: the bag pockets must be positioned at the rear of the rollator, facing
the user.
2.
Repeat on the other side of the bag.
3.
Secure the bag with the safety strap.
5.0 • IN USE
5.1 • Operating the Brakes :
The brakes must be checked before first use, failure to do
so can result in injur.
5.2 • Apply the Brake :
Refer to figure 9.
Squeeze the brake lever up to apply the brake. Let go of the lever to release the
brake.
Note : the brakes are operated independently.
5.3 • Locking the Parking Brakes :
Refer to Figure 9.
Push the brake lever down until it locks into position.
5.4 • Unlocking the Parking Brakes :
Refer to Figure 9.
Pull the brake lever up. An audible click will be heard as the brake is released.
Note: to adjust the brakes, refer to Section 7.1
5.5 • Folding the Rollator :
1.
Refer to Figure 8.
Release the bag security strap, then remove the bag by lifting it up with the
handle. The 'T-brackets' should slide free from the bag slots on both sides.
Note : f the bag is empty it does not need to be removed prior to folding.
2.
Refer to Figure 10.
Gently, push the cross-bar forwards to release the spring lock.
3.
Push the handles together to fold the rollator.
6.0 • CLEANING
•
Make sure that all dirt and debris is removed from around the wheels, axle and
brakes.
•
To clean the bag wipe with a damp cloth. Do not machine wash.
•
Clean the frame regularly, using a general purpose, neutral detergent and
warm water.
•
Please check the suitability of the cleaning products before use. Do not use
abrasive cleaners or cloths as these could permanently damage the surface
and invalidate any warranty.
•
Always allow the product to dry thoroughly prior to use or storage.
FIGURE 5
FIGURE 6
FIGURE 7
FIGURE 8
Apply brake
Lock parking
brake
Unlock parking
brake
FIGURE 9
FIGURE 10
6
4
5
6
Publicidad
