Description Of Symbols; General Safety; Electrical Safety - Silverline 631977 Manual De Instrucciones

GB

Description of Symbols

The rating plate on your tool may show symbols. These represent
important information about the product or instructions on
its use.
Wear hearing protection.
Wear eye protection.
Wear breathing protection.
Wear head protection.
Wear hand protection.
Read instruction Manual.
Contains lead acid battery!
Class III construction (separated or safety extra-low
voltage)
Charger: Class II construction (double insulated for
additional protection)
Conforms to relevant legislation and safety standards.
Environmental Protection
Waste electrical products should not be disposed of
with household waste. Please recycle where facilities
exist. Check with your local authority or retailer for
recycling advice.
Specification
Lamp type: .................................. Halogen
Luminous intensity: ..................... One million candle power
White LED power: ........................ 2W
Red LED power:........................... 0.6W
Battery type: ................................ 6V, 3Ah
Charging time (230V):.................. 8-10hrs
Charging time (12V): .................... 5-8hrs
As part of our ongoing product development, specifications of
Silverline products may alter without notice.
4

General Safety

WARNING Read all safety warnings and all instructions.
Failure to follow the warnings and instructions may result in
electric shock, fire and/or serious injury.
WARNING: This device is not intended for use by persons
(including children) with reduced, physical or mental
capabilities or lack of experience or knowledge unless
they have been given supervision or instruction concerning
use of the device by a person responsible for their safety.
Children must be supervised to ensure that they do not play with
the device. Save all warnings and instructions for
future reference.
Work area safety
a) Do not operate electrical devices in explosive
atmospheres, such as in the presence of flammable
liquids, gases or dust. Electrical devices create sparks which
may ignite the dust or fumes.

Electrical safety

a) Electrical plugs must match the outlet. Never modify
the plug in any way. Do not use any adapter plugs with
earthed (grounded) devices. Unmodified plugs and matching
outlets will reduce risk of electric shock.
b) Avoid body contact with earthed or grounded surfaces,
such as pipes, radiators, ranges and refrigerators.
There is an increased risk of electric shock if your body is
earthed or grounded.
c) Do not expose non-waterproof electrical devices to rain
or wet conditions. Do not submerge non-pressure-rated
devices in water. Water entering an electrical device will
increase the risk of electric shock.
d) Do not abuse the power lead. Never use the lead for
carrying, pulling or unplugging the device. Keep lead
away from heat, oil, sharp edges or moving parts.
Damaged or entangled power leads increase the risk of
electric shock.
e) If operating an electrical device in a damp location
is unavoidable, use a residual current device (RCD)
protected supply. Use of an RCD reduces the risk of
electric shock.
WARNING: When used in Australia or New Zealand, it is
recommended that devices are ALWAYS supplied via Residual
Current Device (RCD) with a rated residual current of 30mA
or less.
Personal safety
a) Stay alert, watch what you are doing and use common
sense when operating an electrical device. Do not use
potentially dangerous electrical devices while you are
tired or under the influence of drugs, alcohol or
medication. A moment of inattention while operating
potentially dangerous devices may result in serious
personal injury.
b) Use personal protective equipment including eye
protection where appropriate. Protective equipment used for
appropriate conditions will reduce personal injuries.
c) Prevent unintentional starting. Ensure the switch is in
the off-position before connecting to a power source.
Carrying electrical devices with your finger on the switch or
energising devices that have the switch on invites accidents.