Battery Charger Safety - Silverline 631977 Manual De Instrucciones

631977
d) Do not overreach. Keep proper footing and balance at all
times. This enables better control of the device in
unexpected situations.
Use and Care
a) Do not force the device. Use the correct device for your
application. The correct device will do the job better and
safer at the rate for which it was designed.
b) Do not use the electrical device if the switch does not
turn it on and off. Any device that cannot be controlled with
the switch is dangerous and must be repaired.
c) Disconnect the power source before making any
adjustments, changing accessories, or storing electrical
devices. Such preventive safety measures reduce the risk of
starting the device accidentally.
d) Store idle devices out of the reach of children and do not
allow persons unfamiliar with the device or these
instructions to operate it. Electrical devices may be
dangerous in the hands of untrained users.
e) Maintain electrical devices. Check for defects of parts
and any other condition that may affect the device's
operation. If damaged, have the device repaired before
use. Many accidents are caused by poorly maintained
electrical devices.
f) Use the device and its accessories in accordance
with these instructions, taking into account the
conditions and the task to be performed. Use of the device
for operations different from those intended could result in a
hazardous situation.
Service
a) Have your electrical devices serviced by a qualified repair
person using only identical replacement parts. This will
ensure that the safety of the device is maintained.
Rechargeable Torch 3-Function

Battery Charger Safety

Use the battery charger correctly
• Refer to the section of this manual relating to use of the
battery charger before attempting to charge the battery
• Do not attempt to use the charger with any batteries other
than those supplied. Keep your battery charger clean; foreign
objects or dirt may cause a short or block air vents. Failure to
follow these instructions may cause overheating or fire
• If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard
WARNING: Do not recharge non-rechargeable batteries
Use batteries correctly
Only charge batteries using the charger provided. Only use
batteries provided with this power tool, or others recommended
by the supplier. Keep batteries clean; foreign objects or dirt
may cause a short. Allow batteries to cool for 15 minutes after
charging or heavy use. Failure to follow these instructions may
cause overheating or fire. When not in use batteries should be
stored at room temperature (approx 20˚C). Ensure that batteries
cannot accidentally short in storage.
www.silverlinetools.com
5