Publicidad
Idiomas disponibles
Idiomas disponibles
fuse blows, unplug the product from the outlet. Replace the fuse as per the user servicing instructions (follow product
marking for proper fuse rating) and check the product. If the replacement fuse blows, a short circuit may be present
and the product should be discarded or returned to an authorized service facility for examination and/or repair.
REPLACEABLE FUSE
User Servicing Instructions
1. Unplug your fan. Grasp plug and remove from the receptacle or other outlet device.
Do not unplug by pulling on cord.
2. Open fuse cover, located on the top of the plug, by using your thumb or a flat head
screwdriver to slide the cover down toward the prongs.
NOTE: Ensure that fuse cover is completely open before attempting to remove fuse.
3. Remove fuse carefully by using a small screwdriver to pry the fuse out of the
compartment by the metal ends of the fuse.
4. Place plug on a solid, flat surface. Insert new 2.5 Amp, 125 volt fuse into fuse
compartment and use a small screwdriver to secure the metal ends of the fuse into the compartment.
CAUTION: Risk of fire. Replace fuse only with 2.5 Amp, 125 volt fuse.
5. Slide fuse cover closed. If fuse cover is difficult to close, make sure fuse is secured in place by pressing down on
metal ends of the fuse.
6. Risk of fire. Do not replace attachment plug. Contains a safety device (fuse) that should not be removed. Discard
product if the attachment plug is damaged.
DO NOT OPERATE APPLIANCE IF THE LINE CORD SHOWS ANY DAMAGE OR IF APPLIANCE WORKS
INTERMITTENTLY OR STOPS WORKING ENTIRELY.
IMPORTANT: During the first few minutes of initial use, you may notice a slight odor. This is normal and will quickly
disappear.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list. If
any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 10 minutes
No Tools Required for Assembly.
ASSEMBLY INSTRUCTIONS
1. Insert the end of the Pillar (O) into the hole of Base (P). Turning the Pillar (O)
while pushing will assure the Pillar (O) is fully seated in the Base (P).
2. At the top of the Pillar (O), loosen the Height Adjustment Knob (N) (turning
counterclockwise). Pull out the Height Adjustable Pole (M) to the desired
height and tighten the Height Adjustment Knob (N) (turning clockwise).
4
Fuse
Fuse cover
Metal ends
O
P
M
N
O
Publicidad
